Thanks a lot Floyd,
but how can you sincronize orion
frequency with SpectraVue ?
Are you using " TenTec orionII - 9mhz if "
option on extradio setup?
Hi, thanks so much.
73 Simone IZ5DKJ
----- Original Message -----
From: "Floyd Sense" <floyd@k8ac.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 09, 2011 1:58 PM
Subject: Re: [TenTec] Question
No - the VFO-B frequency is not shown. If enough folks ask Moe to add
that feature, maybe it will happen. Over time, I've decided that
showing the VFO-B position on the trace is less important that I first
thought. When you move the cursor into the trace window, the frequency
indicated by the point on the cursor does display to the left below the
window. So, you can quickly read the frequency you want to try calling
on and manually set VFO-B via the Orion knob.
I've found that while watching a trace of a pile up, it's rare to be
able to actually pinpoint the guy that the DX station is currently
working. Even when the DX station calls "W4XXX ONLY", you'll still see
6 stations answer him and that will continue till the end of the contact!
73, Floyd
On 10/9/2011 7:05 AM, Simone wrote:
Hi Floyd,
can you see a orion's vfo-b position
on SpectraVue ?
This is very important for pile up split
operations.
73 Simone IZ5DKJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|