| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? ATTN K9YC |
| From: | Jim Brown <k9yc@audiosystemsgroup.com> |
| Reply-to: | k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 09 Dec 2011 14:32:08 -0800 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On 12/9/2011 12:32 PM, amsctalx@comcast.net wrote: > Should I try biasing to the tip and or should I try a dropping resistor? Stick a 4.7K resistor between V+ and the tip, connect the tip straight to the mic input. Shield to chassis. Resistor can be very low power rating, so it can fit inside the connector. 73, Jim K9YC _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? <Jupiter>, Jim Brown |
|---|---|
| Next by Date: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? ATTN K9YC, amsctalx |
| Previous by Thread: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? ATTN K9YC, Richards |
| Next by Thread: | Re: [TenTec] Yamaha CM-500 boomset use with Orion II? ATTN K9YC, amsctalx |
| Indexes: | [Date] [Thread] [Top] [All Lists] |