Dave,
A wild guess based on the only failure on my Delta since brand new -- On of
the issues over the years, that is from the beginning of the Delta II was
that there were surface mounted "vxo" sections that controlled sections of
the frequency coverage. There was a problem with the manufacture when
mounting those components. My Declt II went back to TT a few times over the
years - mostly it was at the other end of the range (10 and 15 meters).
I'd call TenTec - they will hzard a guess before you send it in.
Kris KM2KM
----- Original Message -----
From: "Dave" <dave@n1ix.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, November 18, 2012 4:19 PM
Subject: [TenTec] Delta II problem
The Delta II I recently purchased has a problem and I am wondering if
anyone
else has experienced a similar problem.
Output is very low on 40 meters (2 watts) and it is nonexistent (0 watts)
on
80 and 160. It is good (100 w) on 30 - 10 meters.
I have tried the cpu master reset. I expect that the problem is on the low
pass filter board.
Dave N1IX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|