I use an import chopper dc to control speed on 4pabst fans in a box , in an
enclosure behind the wall which fronts in a nice cabinet, with multiple 3"
dryer hoses on multiple shelf levels, evacuating hot air. I use the hoses also
to decouple fan noise.
My Acom amp , along with network switch, router, magicjack, raid netdrive is in
the enclosure ,not the operating room... A kpa 500 is on a shelf...And the
icom 7800 make heat , also a k3...and other stuff.
Pictures by googling. Ny9h, click on "see more shack pictures"
Now the kicker...in the winter I vent heat back into the room, in the summer it
vents into the garage, which is the adjoining room.
Bill
Sent from my iPad
On Mar 7, 2014, at 3:18 AM, K8JHR <jrichards@k8jhr.com> wrote:
> I made a fan built into my shelf system to help the amp vent hot air. I used
> an Off-On-Off switch with a single resistor to accomplish that feat. This
> gives me high and low speed with just a flick of the switch.
>
> Why is a diode better than a resistor? OR is it just another way to skin the
> same cat?
>
> I will have to send you some photos off list, as it turned out nicely. I did
> this even though I think I cut enough air holes in the shelf to accommodate
> the hot air, but figured this would be better in any case - cannot be too
> safe, ya know.
>
> ------------------- K8JHR --------------------
>
> On 3/7/2014 2:51 AM, Rick - DJ0IP / NJ0IP wrote:
>> That is very good.
>> Try using diodes instead of a resistor.
>> Use a string of 1N4004 or similar.
>> Each diode drops a good half volt.
>> You can even make it multi speed if you add a small switch.
>> ______________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|