Seem to recall that Tentec has a "Y" type connector that will allow one to
use two devices such as a soundcard and amp keying line.
Also, seem to recall the amp keying accessory {318} has a 2nd DIN that
allows for amp keying delay plus a second accessory.
Might check with Paul in Service on this.
73
Bob, K4TAX
----- Original Message -----
From: "John" <k4avx1@windstream.net>
To: <tentec@contesting.com>
Sent: Saturday, September 20, 2014 11:21 AM
Subject: Re: [TenTec] din connector, news from Hall Mountain KY
Thanks to everyone for the info on the Din (not mini-DIN) connector on
my Eagle. I guess it's symptomatic that I would think the connector is
smaller, since I'm older since I put one on!!
I took early advice, went on E-Bay and found the amp line custom built.
But I already have those pins connected on a crooked connector using
one of Mike's amp keyers, which incidentally, works like a charm. Hope
he can make them available again...
On eBay, I found a male two ended 8 pin DIN cable at a reasonable price.
It's on its way, and I can redo the amp circuit and make use of the
other pins as needed, IF it has full wiring for all pins.
In other news, death to my Omni 6+, as it just came back from the factory
un-fixable. Brain dead. Can use the filters in the Corsair II, that I
put the
DDS Vfo into. It was a great rig.
Learning more about the Eagle and I like it very much. Worked two new
DX countries last night, and plan to work the S.C. party today, perhaps
the Scandinavian Contest if bands are decent.
Thanks again for all the help,
73, John, K4AVX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|