[Top] [All Lists]

[TenTec] Using a Mac to install OMNI VII firmware

To: "TenTec@contesting.com" <TenTec@contesting.com>
Subject: [TenTec] Using a Mac to install OMNI VII firmware
From: "Silevitch, Michael" <m.silevitch@neu.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 10 May 2015 12:14:13 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I have just purchased an OMNI VII and will be updating the firmware. I would 
prefer to use my Mac computer rather than a PC for this. I have a serial to USB 
adapter which should work to connect the OMNI to the Mac (or PC for that 
matter.) Any guidance would be appreciated. 

I may also want to operate the OMNI remotely using a Mac rather than a PC. 
Again any advice would be appreciated. 

    Michael K1PEV

Sent from my iPad
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>