[Top] [All Lists]

Re: [TenTec] Dayton

To: tentec@contesting.com
Subject: Re: [TenTec] Dayton
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 17 May 2015 09:27:38 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
In the first paragraph I said "making the receiver work down to 100 kHz." Early users of the new K3SYNA synth board in their K3s report listening to signals in the experimental ham band below the AM broadcast band and to services in the range of 300 kHz.

73, Jim K9YC

On Sun,5/17/2015 2:13 AM, Barry N1EU wrote:
I think they also added low frequency coverage.

Barry N1EU

On Sun, May 17, 2015 at 4:49 AM, Jim Brown<k9yc@audiosystemsgroup.com>

>On Sat,5/16/2015 3:04 PM, Duane Calvin wrote:
>>What's different in the K3S from the K3?
>Here's my take on it, after studying what Elecraft says on their website.
>(I didn't go to Dayton).
>New I/O board, solving a shortcoming with the original K3 and adding USB
>control and audio I/O via USB, new Synthesizer board, making a significant
>improvement in phase noise and also making the RX work very down to 100
>kHz. Improved audio from the speaker. Integrated RX preamp improves
>performance on 6M, 10M, 12M.

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>