Thanks Carl. I think you are right about the headphones - the 'swamping
resistor' is achieving the same thing, but I might look for a higher
impedance set. Only other set I have are 32 Ohm, and that sounded the same
as the 8 Ohm set.
What kind of .01 caps, and where should I put them?
-Josh
On Tue, May 30, 2017 at 1:57 PM, Carl Moreschi <n4py3@xxxxxxxxxxxxx> wrote:
> I don't think 8 ohm headphones were correct. I think much higher
> impedance phones forces you to turn the volume up and drown out the hum.
>
> Direct conversion receivers are susceptible to a hum because the VFO is
> running at the operating frequency and can mix externally with 60 hertz.
> This is then detected in the receiver as a hum. I used to put .01 caps
> across my HW8 power supply to kill this RF and remove a lot of the hum.
> Electrolytic caps don't work at RF.
>
_______________________________________________
TenTec mailing list
TenTec@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/tentec
|