TenTec
[Top] [All Lists]

[TenTec] Omni VI display

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] Omni VI display
From: Stan Gammons <s_gammons@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 24 Feb 2018 22:23:05 -0600
List-post: <mailto:tentec@contesting.com>
Hi Everyone,

I have an Omni VI that likes to throw fits now and then and not display some of the segments on the display.  Seems like every time I deoxit the pins and or resolder connections it works for awhile then it the same ole same ole.  Ideas on a permanent fix for this problem?   I thought about hard wiring the driver board and display board together.  That would make it a pain to take them out if ever needed to though.
73

Stan
KM4HQE

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>