I have a known good, working display assembly with driver board.
Gary
> On Feb 24, 2018, at 10:23 PM, Stan Gammons <s_gammons@charter.net> wrote:
>
> Hi Everyone,
>
> I have an Omni VI that likes to throw fits now and then and not display some
> of the segments on the display. Seems like every time I deoxit the pins and
> or resolder connections it works for awhile then it the same ole same ole.
> Ideas on a permanent fix for this problem? I thought about hard wiring the
> driver board and display board together. That would make it a pain to take
> them out if ever needed to though.
>
> 73
>
> Stan
> KM4HQE
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|