Try reflowing the solder on pcb to connector pins. Maybe one of them is
cold solder joint.
On Sat, Feb 24, 2018 at 6:23 PM, Stan Gammons <s_gammons@charter.net> wrote:
> Hi Everyone,
>
> I have an Omni VI that likes to throw fits now and then and not display
> some of the segments on the display. Seems like every time I deoxit the
> pins and or resolder connections it works for awhile then it the same ole
> same ole. Ideas on a permanent fix for this problem? I thought about
> hard wiring the driver board and display board together. That would make
> it a pain to take them out if ever needed to though.
>
> 73
>
> Stan
> KM4HQE
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|