Re: [TowerTalk] Re: Thrust Bearing Usage

[Don Havlicek <n8de@thepoint.net>]

An easier way to service a rotor when there is only a top-mounted 
bearing is to make a bracket of angle with U-bolts that attaches inside 
the tower above the rotor and holds the mast securely.
The Hy-Gain boom-mast bracket mounted on a piece of 2"x2" angle works 
excellently in most towers.
Don
N8DE

David Robbins K1TTT wrote:
> > I've been monitoring this interesting thread. I haven't had the need
>
> to
>
> > replace a rotor (yet) and I only have one thrust bearing on the top
>
> (flat)
>
> > plate. The rotor is 4 feet down the tower with the rest of the 20 foot
>
> C-M
>
> > mast and two beams above. It seems to me that if you lift the mast out
>
> of
>
> > the rotor and clamp it above the bearing, it will very much want to
>
> sway
>
> > and
> > tilt with the better part of the weight above the tower. It seems you
> > would
> > have to do some sort of stabilization just above the rotor to have a
> > fighting chance - a sort of faux bearing. Am I reading this correctly
>
> or
>
> > is
> > my physics off ?
>
>
> Your physics is fine, 16' above the bearing and 4' below with all the
> weight above will definitely want to tip over.  To keep it from tipping
> a real bearing does the job also.  You can rig it temporarily by tying a
> very tight wire or rope loop as low in the mast as you can around each
> tower leg.  3 separate tight loops do a decent job of holding it upright
> while the rotor is replaced.  Note, don't take a shortcut and just loop
> around a leg then loop around the next leg without tying it off on each
> one or vibration will cause it to work its way off to one side or
> another making it very hard to get back straight.
>
> On my flat tops I always put a second bearing just for that purpose
> above the rotor.  To keep it from binding I leave it loose until needed
> to remove the rotor.  And I do let the top bearing carry the weight of
> the mast and antenna(s) and leave that 1/4" or so gap below the mast so
> its easy to remove the rotor when needed without jacking up the mast.
>
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://www.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
>  
>
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk