[Top] [All Lists]

Re: [TowerTalk] Used Phillystran Testing

To: "Keith Dutson" <>,"TowerTalk" <>
Subject: Re: [TowerTalk] Used Phillystran Testing
From: "Clint Talmadge" <>
Date: Mon, 21 Aug 2006 09:35:59 -0500
List-post: <>
Phillistran gets  its' strength from the fibers inside while the black 
plastic sheath only protects those fibers.  If the sheath is not 
compromised, the inside should be O.K. I would pay particular attention to 
the ends where the grips are located and the ends where there should be a 
cap glued on.  The cap was to prevent water wicking up into the fiber and 
then freezing, spitting the sheath and exposing the fibers.

I am in the planning stages for a new tower and intend to use Phillistran 
and have noticed that NOBODY sells used Phillistran on the swap boards.

Clint  --  W5CPT

----- Original Message ----- 
From: "Keith Dutson" <>
To: "TowerTalk" <>
Sent: Monday, August 21, 2006 9:00 AM
Subject: [TowerTalk] Used Phillystran Testing

>I have some used Phillystran and want to use it again to put up a new 
> Is there any advice on inspecting and testing it?
> 73, Keith NM5G
> _______________________________________________
> _______________________________________________
> TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>