Towertalk
[Top] [All Lists]

Re: [TowerTalk] 160-m. Inverted L Question

To: towertalk@contesting.com
Subject: Re: [TowerTalk] 160-m. Inverted L Question
From: WD0M <WD0M@centurytel.net>
Date: Thu, 13 Dec 2007 11:39:48 -0700
List-post: <mailto:towertalk@contesting.com>
I'll certainly second that.  I used my Palstar ZM-30 analyzer on all my 
antennas (except the SteppIR) and it made a HUGE difference.  The SWR on 
my 160 inverted L is spot on at 50 ohms where I normally operate.

73

Joe Hannigan - WDØM
Pagosa Springs, CO

http://www.WD0M.com
http://www.pagosarocks.com
http://www.quiltqueen.net



Bill Turner wrote:
> ORIGINAL MESSAGE:
>
> On Wed, 12 Dec 2007 19:18:03 EST, RLVZ@aol.com wrote:
>
>   
>> 1) Some people report that the 160-m. Inverted L can be fed directly with  
>> 50 
>> ohm coax with good results.  Is that true?
>>     
>
> ------------ REPLY FOLLOWS ------------
>
> If you are concerned about getting an exact 50 ohms at the feedpoint,
> a simple L-network will do it for you. See any ARRL handbook or
> Antenna book. 
>
> Also, I strongly recommend getting an SWR analyzer such as one of the
> MFJ series. You will wonder how you ever got along without it.
>
> 73, Bill W6WRT
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>