Towertalk
[Top] [All Lists]

Re: [TowerTalk] HDX-555 relay settings

To: towertalk@contesting.com
Subject: Re: [TowerTalk] HDX-555 relay settings
From: Dan H <n5ar@air-pipe.com>
Date: Mon, 30 Aug 2010 14:08:58 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
  On 8/30/2010 1:15 PM, Ed Magnuson wrote:
> Thanks, Doug. I will set them both the same and for about 2 seconds and see
> if that works.  My tower is at our country place, which we visit on
> week-ends so will check it out then. This problem follows my tilting the
> tower to the ground to paint the four Steppir fiberglass tubes; now upright,
> the motor does not start. So relays may not be the problem but last time the
> tower would not crank up, replacing a relay was the remedy. We shall see.
>
> And thanks for giving this tower dummy an idea of what the relays do. Hi.
>
> Ed W1MAG
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
Ed: I would set them for much longer than 2 seconds. I believe the 
purpose is to be sure the motor lifting the tower coasts to a complete 
stop and the tower comes to a halt before you reverse it. Don't ask me 
how I learned about this, Hi.
73, Dan, N5AR
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>