Dave,
Good info on testing for interaction Dave ! I will check the F/B before and
after
as you describe.
thanks,
Bob
K6UJ
On Feb 6, 2011, at 8:02 AM, Dave Hachadorian wrote:
> The D40 is not resonant on 10, 15 or 20 meters, so the dipole should be ok
> parallel to the C3. I have a 40-2CD six feet above a KT-34XA, elements
> parallel, and all is ok. Those antennas have been there for 30 years, and I
> do pretty well in contests, considering that the XA is at 48'.
>
> The D40 has a broad resonance around 18 MHz, so if the C3 is supposed to
> work there, there will be a problem. The D40 should be a pretty good 18
> MHz antenna, swr about 2.5, well within tuner-by-Eimac range.
>
> The best way to determine if there is any degradation in the C3 is to do
> front-to-back measurements with a local ham (0.5 mile to 20 miles distant).
> Have him transmit, while you do the front to back. Procedure is here:
> http://lists.contesting.com/archives//html/Towertalk/1998-11/msg00502.html
>
> Do the f/b on the C3 before and after installing the D40 to see if there is
> any change. F/b is the most sensitive measurement of interaction.
>
> If f/b is degraded, add six feet to the 40 meter feedline and see if it
> helps, or short the 40M feedline while testing the C3.
>
> If that doesn't work, then put the D40 orthogonal to the C3. If that
> doesn't work, take it down, or add more separation.
>
>
> Dave Hachadorian, K6LL
> Yuma, AZ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|