Hello,
I will do a ground installation for coaxial of the antennas, rotor lines
etc.
Near the shack, will do a hope 6 ft deep to put some bronce bars, cables,
something else I find.
Then will put two bars going up and a horizontal bar soldered to them to put
the bulkheads connectors.
I have some question:
- any advice about how to solder the bars outside the ground? the
bars that will form the Π
- I need to solder the bars that are going from the hole to the
surface or just is OK if they are in touch with all the wires, bars I put
inside?
- May I use concrete to cover all the bronce I put inside the hole
and over it ground, or just ground over the bronze?
Thanks,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|