Jim,
With my 2EL Force 12 40M yagi, I followed Tom Schiller's guidelines and
set it up initially at 15 feet
above the ground. When I raised it up to 70 feet the resonance
frequency increased by 20khz. From 70
to 90 about 2khz. This is what he said to expect in his manual. No
modeling or study done. Just
my results with the install.
I have tried the start out on the saw horse routine in the past with
yagis. The resonant freq ramps up on a
very steep curve and I had erratic results. On sawhorses, even the dog
walking by would change the tuning :-)
If the model shows that increasing the height from 30 INCHES to 60ft
results in a 215khz increase in resonant freq this could be realistic,
but I think we are spinning our wheels to do the initial tuning this
close to the ground.
73,
Bob
K6UJ
On 5/30/16 9:20 AM, Jim Thomson wrote:
Date: Mon, 30 May 2016 03:42:47 +0000 (UTC)
From: Dan Maguire<djm2150@yahoo.com>
To:<towertalk@contesting.com>
Subject: Re: [TowerTalk] Change in Frequency As Antenna Height Rises
Above Ground
K9RX (StellarCAT) wrote:
There's no "probably" to it! It is lowest (in frequency) closet to the ground.
[snip] Finally on 40 meters I saw as much as a 300Khz change from 32" (on saw horses) to
37' on just one element of the yagi... I believe it was about 150 Khz from 8' to 37'. And
think there might be an additional 20 Khz or so shift from here on up to probably 50' or so.
For a 40m dipole model (length 66 ft, diameter 1 inch, aluminum, 29 segments, over
"Average" ground) the chart below shows (red trace) the frequency of minimum SWR(50)
and (blue trace) the frequency of resonance (jX=0 at feedpoint) at heights from 2.5 ft
(30") to 100 ft.
http://s33.postimg.org/vjtgi392n/resonate3.png
While it is true that the frequency (either one, take your pick) is roughly 300 KHz
higher at 37 ft vs 30", and is higher still up to about 60 ft, from there to
about 100 ft the frequency *decreases* as the height is increased. It also
*decreases* from about 10 ft to about 25 ft. So it seems that no blanket statement
can be made. Whether the frequency increases as the height increases depends on
where you start looking at things, at least for this simple model, which may or may
not be an accurate representation of Gary's one element from a Yagi.
Dan, AC6LA
## OK, so resonant freq increases from 7025 to 7240.... when height
changed from 30 ft...to 60 ft. Great, so how the hell am I to tweak each
ele on my 3 el 40m yagi ??
F12 sez to tweak the REF at 6910 DE at 7070 DIR at 7500. ( 340N)
I find it really hard to believe that the resonant freq will increase by
215 khz.... simply by changing height from
30 ft to 60 ft. Thats a huge amount. Something is amiss in the model.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
