| To: | "john@kk9a.com" <john@kk9a.com>, "towertalk@contesting.com" <towertalk@contesting.com> |
|---|---|
| Subject: | Re: [TowerTalk] To pin or not to pin |
| From: | Al Kozakiewicz <akozak@hourglass.com> |
| Date: | Sun, 28 Aug 2016 23:58:19 +0000 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
If you are drilling a hole why do you need M8 hardware instead of 5/16 or even go larger which is readily available in stainless steel. I do not believe that stainless steel bolts come in the same grades standards as steel although some stainless materials may be equivalent. John KK9A No ME here either, but I think the idea is that the bolt acts as a shear pin. You want it to fail before the rotor or mast. Al AB2ZY _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Strength of installation raising cable for the LM470?, Dan Bookwalter via TowerTalk |
|---|---|
| Next by Date: | Re: [TowerTalk] To pin or not to pin, mike repinski via TowerTalk |
| Previous by Thread: | Re: [TowerTalk] To pin or not to pin, john |
| Next by Thread: | Re: [TowerTalk] To pin or not to pin, mike repinski via TowerTalk |
| Indexes: | [Date] [Thread] [Top] [All Lists] |