Re: [TowerTalk] tower base rod weatherproofing

[Les Kalmus <w2lk@bk-lk.com>]

Bob,

The installer who did my tower used plenty of NeverSeize on the non 
galvanized bolts and nuts and I had no problem removing them 12 years 
later. I was surprised to find them prepared that way but very thankful.
Les W2LK


On 4/27/2017 6:39 PM, bob wrote:
>   
>
> I have some non-galvanized bolts/rods embedded into a concrete base for a
> short tower mounting plate.
>
>   
>
> What would you recommend to coat them in to keep corrosion/rust demons away?
>
>
>   
>
> They are composed of hardened 5/8 x 18 threaded rods (non-galvanized) and
> the bolts are used for adjusting the tower for plumb, so I'd like to
> preserve the ability to adjust them at some point again.  So something that
> would leave the nuts still adjustable down the road is preferable, even if
> has to be re-sealed/coated at that time its fine.
>
>   
>
> Suggestions?
>
>   
>
> -bob
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk