Just my $.02 on the subject. #1. I've found that using sheet metal screws
will upset the metal enough to make disassembly a bear.
#2. Most of the time, if you can't get a hose clamp tight enough to hold the
inner/smaller element it is because you have to much of you favorite assembly
anti-ox paste on the joint. I personally use a green "Scotch-brite" kitchen pad
to
apply the paste. I cleans the metal, and leaves just enough anti-ox on the
metal.
((HINT: After use, don't put the green pad back in the kitchen)) <GRIN>
73
K9WN Jake
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|