I probably have 10 or 15 RG-1000 shells sitting around here. Stupid question, but WHY do you want to put RG1000's back in the cases instead of putting them outside tower mounted in NEMA boxes?
hmm... what kind of radios are you running in your AP1000? I've heard that the Prism cards can cause an AP1000 to overheat but stock 35mw Lucent cards shouldn't cause much heat build-up. volts Should
1) This is actually a Karlnet and CB3 question.... is there any way to have a CB3 unit show up as anything other than generic "PRISM I" in the association list on a Karlnet enhanced 802.11b SEC acces
Yes I was comparing the KN-100 to an RG1000. But that is because the KN-50 does not support Karlnet SEC. For that matter, it appears that the KN-50 doesn't have enough intelligence to support NAT, Ro
We found that running at a lower voltage helped with breakdowns. We were running one Karlnet board on a Hyperlink 48V-DC injector with 150ft of cat5. The Karlnet board was locking on hot days. We the
As far as I am aware, a Karlnet SEC client can connect to any 802.11b compliant AP when the CPE is placed in routing-mode or when the CPE is placed in NAT-mode. Bridging mode is different. A Karlnet
What cards will this board support? Prism 2.5 and Lucent? What about 5.X cards?? any support for those? applied AMP Activity Flash AMP Activity range, our
We checked every channel on Thursday and then again on Friday. I'm afraid that the gear just isn't going to work any better until I can reconfigure it (on top of the roofs). I have scheduled with our
Are both towers running on the same or close to the same channel? You should have proper channel separation between those towers or else your AP will "commit-suicide" (reboot) every time it gets conf
What's your noise floor look like? If you have a -67db noise floor, you won't make that link happen. You might want to check noise floor first and see if you have any "clean channels" to work with. I
What exactly does this do? - Inhibit Private NAT through selected Interfaces Does this somehow block a customer from running a NAT router (like a Linksys Cable-Modem-router) behind say an RG1000? If
Anyone from Karlnet care to enlighten us and clear up our speculation??? If they have found a way to block NAT, I have an immediate need for some upgrade licenses! of that
ok... if you don't mind me asking, how exactly would one firewall against NAT? What sort of rules would I have to add? Any helpful links that explain how to firewall against NAT? IP's a it default fi