The left connection is tx/rx and the right is rx only. Randy I see that it has two antenna ports. Do you have to have two external antennas hooked up to this card? Does it only put out 100mw per side
Can you try form the other direction? Randy http://www.htonline.net/temp/ link reported not act full. Anyone have -- -- -- -- -- -- _______________________________________________ Karlnet mailing lis
Are trying to deliver 3mbps on some cpe's? I have 63 cpe's on one radio of the AP-1000 but with 3mbps into it but the best throughput is about 1.6-1.8 mbps. The other radio goes to a link to another
I have an AP100 with 2 200mw engenius card it one side link satellite and the other a base. It has been up with only twice lock up from over a year. I have found on other ap1000's that I need to use
Will that firmware solve the retransmits with RG boards? It really depends There are some on what you're using Like, if you've got the KN-50, there is one load that works w/ Hermes I & Intersil, and
I see a lot of retransmit in the turbocell station entries in the Configurator mostly less that 10% but some up to 50%. The base to cpe snr are 25+. Also in the interface monitor, under 802.11b/2 int
Same problem here but with an AP1000 with indoor amp running Version 4.43 karlnet I restart the amp traffic comes back. Very frustrating. Randy Hi All, Just wondering if anyone else is experiencing a
All RG's(65 users) with the latest firmware retransmits are mostly 10 % or less but I have a couple that are 20%. Using the Demarctech 100mW card into the YDI amp and then 90 ft of cable 15dbi omni.
I have 5 Ap1000 this is only happening on one with 4.43j version (128user). Randy Is anybody running v444-2 experiencing this issue? [mailto:karlnet-bounces@WISPNotes.com] On [mailto:karlnet-bounces@
Has anybody heard anything from KN about the total loss of traffic. It is hitting me bad today from 4-15 minutes. Randy Byrd I don't run any Cor's or Ror's with anything other than firmware 4.15 whic
Yes I don't have that checked. Randy Randy, I haven't heard anything back from karlnet except for the "information request" Quick question for you - do you have block inter-client communications enab
I would be great to use the Configurator ver 5 . I wonder where I can download it. Randy Hello all, After discussing this with our main build engineer he states the version 5 of the Configurator must
Has anybody had any problems with customers complaining that the internet is down when browsing in Internet Explore in Windows XP but you can ping the gateway with good replies. Then you can reboot a
On my system I have only seen the Ethernet port on the customers router/nic side fail. Most likely ethernet port failure on the rg1000 or at the customers hub/switch/router Check the up.down status w
Has anybody had a RG-1000's Ethernet port fail and request Karlnet to release the MAC so it can be used on another RG-1000 to take its place? I have requested this to from CWLab, where I bought the l
Do you think that its because you done sell their product anymore? Randy Just an FYI We're just the "unlucky" messenger -Charles -- CWLab - About Broadband Communications Come visit us at CWLab's Tec
That's not true Charles you did one for me that was hit by lightning in May. Randy No...this policy was put into effect about 6 months ago, before the merger As for selling / not-selling the product,
Yes Was that over a year old? Maybe the change in policy was a little more recent... -Charles -- CWLab - About Broadband Communications Come visit us at CWLab's TechNet: Free Wireless Training Briefs