hi, Just wondering if it is possible to use MixW to send CW without using soundcard input? I can move the frequency from MixW but I can't do anything else. I have set the baudrate to 57600 and checke
heh - had a nice QSO this morning around 1115Z with Mike W3MC - he's getting lots of Ten-Tec ops to work :-) Oh boy how I do love ten-tec QSK... 73, Jason W0JSB
How high is too high...? 2:1? 3:1? I don't want to damage the finals. I'm able to tune my 80m ant to 160m but with an swr of 2.4:1 with the power level set to 40%.
FS: I still have the Orion up for sale ...one month old...perfect condition... I wish you were in the Boston area - i'd love to try one out. 73 Jason W0JSB
What serial numbers do you guys have? Sounds like differences in hardware.......... 73 - Jason W0JSB Just For The Record, mine is working as described below.. Prior to the upgrade, the radio ran smoo
I use the Studio One mic on my Jupiter and based on some audio reports from very distant DX I have had the best luck with these settings below: TX Filter BW: 2400 Speech Proc: 50% TX Roll Off: 550Hz
I upgraded from 1.24 to 1.25 today with WinXP and COM2. Piece of cake. Now if there was a feature so I could just turn AGC off so I could control it manually via RF gain :-) regards, Jason W0JSB
Using unbalanced HV (or medium voltage) power distribution seems to be a new thing here in the USA. I have been looking at power lines as long as I can remember, and the use of one hot lead and one g
Power companies in PA have been "polling" meters (reading remotely) for some time using this technology. An occasional half second isn't bad; imagine that noise 24/7/365. I'm very afraid of that - am
The Noise Reduction circuit with the latest update (1.25) seems to be hosed up. When I press the NR button on the radio, it mutes the receiver. If I have the N4PY control software on, moving the sli
No problem on this end after dumping 1.25 in the Jup. You might try reloading the update. I wish TT would write the necessary programming that saves all user settings when the rig is powered off. It
I hear a lot of this around 14.032. Same on all rigs I have although my Jupiter does a fine job of attenuating it with NR on. regards, Jason W0JSB Boxboro, MA