-- StripMime Report -- processed MIME parts -- multipart/alternative text/html audio/x-wav application/octet-stream -- StripMime Errors -- A message with no text/plain section was received. The entir
Winston, again to get it to tune the SWR down further. Is this the way it is supposed to operate? wrong here? Please help. I, too, have an LDG AT-11MP and think it is a great tuner. I was disappointe
Icom button when building should used way reports buttons I agree with the comments on the AT-11MP. However, I do miss the convenience of one touch tuning. I have created my own Pegasus control soft
The Pegasus Programmer's Reference Guide (PRG) says that the signal strength query returns results that represent S-Units (and fractional S-Units). This makes it pretty easy to display signals up to
I wonder if we'll ever see a true SDR from a major manufacturer. If the radio could be upgraded by new firmware / software, there's no reason for someone to upgrade the hardware. Right now, the ham r
Scott, Thanks for the thoughtful comments. performance. I haven't seen (or heard) the Orion yet. However, will going from 69 db to 100+ mean I can actually hear (and work) 10 times more stations with
Bill, Thanks for the update. Since you only run QRP, did you consider the 817 instead of the FT100D? I'm sure the 100D will draw more battery power at 5 watts than the 817. 73, Mark -- Original Messa
I have an Omni V with the N4PY V.9 firmware update. It also comes with the original TenTec microcontroller. The only V.9 hardware mod was the replacement of the microcontroller. The sidetone and RS23
I am writing software to control the RX340. According to the RX340 = manual, configuration switch S1-5 sets the serial byte length to 7 or 8. = However, it seems that the byte length is always 8 rega
Has anyone had any luck using a USB -> RS232 converter to control a = Pegasus? I've tried both the TT software and N4PY and they refuse to = establish communications with the Pegasus. If I reconfigur
Well, I've done a little more experimenting and think I know what is going on, at least with my own software. It may also explain what's going on with the N4PY software. One of the nice things about
Bob, In all the important details, the Jupiter and the Pegasus are the same receiver and transmitter. I did discover that when you do a frequency scan on the Jupiter in front panel mode, the firmware
I'll post this again as I've had no response in a couple of weeks. Perhaps someone new is watching the list and may have some help. Has anyone done anything with the DSP outputs of the RX-340? I thin
Well, it's not repair, but I may have the shipping record. Earlier this year, the TenTec store had a special on the LDG Z11 QRP tuner. I called and ordered one that morning. I'm glad I didn't wait be
After using a Pegasus for almost two years, I have my first opportunity = to play with a Jupiter. A friend brought his Jupiter over to my house to = have me update the firmware ( he does my plumbing,
Try BuxComm www.buxcomm.com specifically http://www.buxcomm.com/page1/bccpage1.htm there are inline 4-pin male connectors (2/$5) that should do the trick Mark -- Original Message -- From: "Kent A. Ba