Amps
[Top] [All Lists]

[AMPS] Band Switch Heath SB-1000

To: <amps@contesting.com>
Subject: [AMPS] Band Switch Heath SB-1000
From: measures@vc.net (Rich Measures)
Date: Sun, 27 Apr 97 11:57:07 -0800
>At 11:14 AM 4/27/97 -0400, you wrote:
>
(Tom Rauch) 
>>The SB-1000 band switch, when properly installed, will handle normal
>>operating voltages. Unfortunately several things went wrong in the
>>SB1000. Heath decided to NOT install an anti-corona washer. That reduced
>>the voltage breakdown.
(Phil Clements)
>I built one of the last SB-1000 kits. It DID specify the installation
>of the washer on the switch contact. It sticks in my mind so well because
>I had never seen this done before, and Heath did not explain what function
>it had.
Oops.  I'll bet a large pizza with 4 toppings that this gets ignored, 
Phil. 
(Mr. Rauch) 
>>None of this stuff is magic or rocket science. It's all common sense and
>>normal engineering, and can be verified by traditional math. I've
>>measured PA's producing over ten times the normal operating voltage in
>>the tank during load faults.
"Over ten-times" normal in an SB-1000 would be over 25,000 peak volts.  
Measuring this much HF voltage is way beyond the capability of my 
Tektronix HV RF probe.  . 
 How did you make this measurement, Tom? 
 How did you keep the bandswitch from arcing during the 25,000+ peak 
volts measurement? 
 How did you keep the Tune-C from arcing during the 25,000+ peak volts 
measurement?
Rich---



R. L. Measures, 805-386-3734, AG6K   


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com

<Prev in Thread] Current Thread [Next in Thread>