[AMPS] resistors

[km1h@juno.com (km1h@juno.com)]

On Sat, 20 Feb 1999 10:11:49 -0800 "Ron Spencer" <n4vos@mis.net> writes:
>
>Hello I need some help here. I working on the power supply for the 
>8877
>tube. The question I have is how to mount the bleeder resistors
>I have two ohmnite about 7 inches long, they are 100 watt 100k which 
>will be
>in series. Can I use a thur bolt ? or would this be two risky ?

If you use the original style self centering end clamps and thru bolt you
will have plenty of reserve voltage rating at 4KV so half that is very
safe.   Mount to a bakelite board or a ceramic stand-off. DO NOT mount
directly to the chassis as I have found that the end mounting terminal
tolerance varies quite a bit from the actual end of the resistor.

73  Carl  KM1H



>
>Ron n4vos@mis.net
>
>
>--
>FAQ on WWW:               http://www.contesting.com/ampfaq.html
>Submissions:              amps@contesting.com
>Administrative requests:  amps-REQUEST@contesting.com
>Problems:                 owner-amps@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm
>
>

___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm