This all started when I went to calibrate the plate current meter. That is
when I discovered that the plate current was actually much higher that I
thought. The dummy load is not an issue since it has the same indications
using the antenna also with a 1.1:1 vswr.
Lane
Ku7i
----- Original Message -----
From: measures <measures@vcnet.com>
To: Mike Willis <Mike@g0mjw.freeserve.co.uk>; AMPS <amps@contesting.com>
Sent: Thursday, January 06, 2000 5:27 AM
Subject: Re: [AMPS] abnormallly high plate current
>
> >
> >What is the bias voltage ? Have you tuned it up properly and are both
meter
> >shunts still the correct resistance ?
> >
> Checking the meter accuracy is a good idea. So is measuring the R of the
> dummy load. Wattmeters can not give accurate readings unless the load is
> 50 ohms, as checked with a DMM. // Heath cantennas are especially
> vulnerable to damage because they use a resistor that is rated at 50w
> continuous.
>
>
> - Rich..., 805.386.3734, www.vcnet.com/measures.
>
>
> --
> FAQ on WWW: http://www.contesting.com/ampsfaq.html
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|