>
>I checked my voltage at the outlet for my amp. and it measured 235
>volts. This was measured with a B&K 20k ohm voltmeter. Factory setting
>for the AL-1200 filament xfmr line voltage is setup for 245v. There are
>taps for 232v and less, would it be advisable to switch my tap to the
>232v setting??? Thanks de Phil W2GE
>
The critical thing is filament v at the filament pins. For max. tube
life, the low end of the rated v range is best.
- Rich..., 805.386.3734, www.vcnet.com/measures.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|