Amps
[Top] [All Lists]

[AMPS] Power out indicator

To: <amps@contesting.com>
Subject: [AMPS] Power out indicator
From: 2@mail.vcnet.com (Richard)
Date: Tue, 19 Feb 2002 04:36:11 -0800


>
>
>-----Original Message-----
>From: Peter Chadwick <Peter.Chadwick@zarlink.com>
>To: amps <amps@contesting.com>; 'W8JI@contesting.com' <W8JI@contesting.com>
To: <amps@contesting.com>
>Date: 19 February 2002 08:06
>Subject: RE: [AMPS] Power out indicator
>snip
>>>People just need to learn to use the maximum possible
>>>capacitance that allows a match in a T network.
>>
>>Of course. And to remember that the L network has a Q fixed by the ratio of
>>impedances, so that the extra component in a T can allow a much lower 
working Q
>>and so offer higher efficiency.

>I'm wide open to correction here, but I think If you are matching between
>two resitances, the L match has the lowest loaded Q. 

Yes, you are correct, Steve. 

>...
cheers

-  R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K, 
www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>