So, when I power up my amp, I see 3910vdc on my plate. The way I have it
configured, I put 330vdc on the screen grid
and -130volts on the control grid., when I bring the control grid to -69v, the
tube pulls current. The voltage on the plate is
dropping to ~3600 to 3700. Is this the value I would use to figure the
impedance of the tube for tank calculations?
Initial tank settings using ~2k ohm seems to work, but i'm going to rip all
that out and(try to) make this go from 160 to 15, versus
what I have now 80, 20 and 40.
forget 10 too much C left.
thanks
Chuck Partain
SPG Compatibility Engineering
maxtor corp
333 south st
shrewsbury, ma 01545
508-770-3496
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|