Hello again,
Well a couple weeks back you all might remember I bought a Al 811 an there was
a tube that was cracked and causing it to blow fuses. Well I ordered 2 new
tubes since I only found one to be bad. I got them in today and dropped one of
the new Penta 811s in and fired the amp up. Well I did not matter where I
turned the load and tune it did not change on the meter.
Well I lifted the cover and keyed down with about 20 watts and I have only got
1 tube buring. One of the new Pentas is glowing but the other 2 are not
including one of the new ones.
What could this be. I checked inside and did not see anything loose.
Remember I am all new to amps to please put it in a Novice Terms...I have never
ran amps on barefoot and qrp.
Troy
N5ARK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|