I have a commander hf-2500 (pair of 3cx800a7's, no qsk) that seems to be
working fine. However, during cqww cw last week I had to pull it off the
20m station because it was making a broadband noise while on receive. I put
it back on the station today and it isn't doing it now. I tried warming it
up a bit and it still didn't do it....though its obviously not as warmed
through as after 40 or so hours of cqww. The only other thing I noticed is
when it was doing it the plate voltage dropped a bit, maybe 50-100v, but I'm
not sure if that was a cause or effect since the line voltage sag from the
other stations can make the hv sag a bit here. Any ideas where to start
looking??
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|