On the other side :
I have also used PTFE as dielectricum in the plate coupling cap
in a 4CX250B amp with a 1/4 coaxial plate circuit...No problems
with that one...on 144 Mhz ! Points toward poor polishing job in the
160 amp....
Put a piece of ptfe in a microwave with a glass of water (to protect/
provide load for the tube) and it will NOT heat the PTFE...
That is a good sign...I use to test all materials exposed to strong RF
that way :-) If it heats or melts it is unsuitable,
No virus found in this outgoing message.
Checked by AVG - www.avg.com
Version: 9.0.790 / Virus Database: 271.1.1/2748 - Release Date: 03/15/10
08:33:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|