We all know there HAS to be some kind of matching to get significant power
transfer. It could be this simple:
The rf choke could be sized to provide the needed inductance for an L
match. The series coupling C can be sized to transform the plate load Z to 50
ohms.
That actually would be the lowest loss matching scheme and therefore
deliver the most watts to the antenna.
Q? We don't need no stinking Q! Actually the output C of the tube and
coupling C would force some Q to be present. Maybe just enough?
73,
Gerald K5GW
In a message dated 4/7/2010 4:05:00 P.M. Central Daylight Time,
sub1@rogerhalstead.com writes:
The antenna is the tank circuit? <:-))
73
Roger (K8RI)
Carl wrote:
>
>> ORIGINAL MESSAGE:
>>
>> On Wed, 7 Apr 2010 14:23:16 -0400, "Carl" <km1h@jeremy.mv.com> wrote:
>>
>>
>>> Not if the Pi Net is doing its job.
>>>
>> REPLY:
>>
>> There is no pi-net.
>>
>> Quoting from the original post:
>>
>> "The area behind the second seat was all "open construction" with a 2
>> inch diameter antenna sticking out of the roof and looked to be
>> capacitivly coupled to the anode of the 4CX15,000 without the benefit
>> of any matching network."
>>
>> 73, Bill W6WRT
>>
>
>
> Then I'll change the subject line since you drifted off the original
topic.
>
> Carl
>
>
>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|