Jo Jennings built an amp in the 60's that ran a mess of sweep tubes at 2KW
PEP input. The output tank was a .01 cap. It was even published in QST.
Carl
KM1H
----- Original Message -----
From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
To: <TexasRF@aol.com>; <dezrat1242@yahoo.com>; <amps@contesting.com>
Sent: Thursday, April 08, 2010 11:56 AM
Subject: Re: [Amps] CB amp directly coupled via cap to antenna
>I see some interesting applications for this type of antenna.
> You can have a 80 meter transmitter that will transmit on 80,40,20,15,10
> meters and lots of other frequencies at the same time.
> Field strength measurements would be improved by making use of all these
> harmonics.
> Hi Hi
> 73
> Bill wa4lav
>
> ________________________________________
> From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf
> Of TexasRF@aol.com [TexasRF@aol.com]
> Sent: Thursday, April 08, 2010 11:31 AM
> To: dezrat1242@yahoo.com; amps@contesting.com
> Subject: Re: [Amps] CB amp directly coupled via cap to antenna
>
> With the shunt C from tube anode to ground there would not be a case for
> 50
> +j0 right at the tube.
>
> Also, with tube in the discussion the plate load impedance would be a bit
> higher than 50 ohms anyway.
>
> Agreed?
>
> Now, your vertical idea has some interesting possibilities: By choosing
> the
> length carefully, one can set the R of the vertical to match the plate
> load impedance. You are still left with the need to reconcile the
> reactance
> that remains. Since the tube will be capacitive, perhaps there would be a
> happy coincidence of antenna R +j to handle the match, maybe somewhere
> around
> 3/4 wave length?. If not, careful selection of the coupling C would
> surely
> make it all possible.
>
> 73,
> Gerald K5GW
>
>
>
>
>
> In a message dated 4/8/2010 10:06:13 A.M. Central Daylight Time,
> dezrat1242@yahoo.com writes:
>
> ORIGINAL MESSAGE:
>
> On Thu, 8 Apr 2010 08:29:25 EDT, TexasRF@aol.com wrote:
>
>>
>>We all know there HAS to be some kind of matching to get significant
> power
>>transfer.
>
> REPLY:
>
> If the antenna impedance is the same or nearly so as the plate load
> impedance, no matching network is necessary. A half wave vertical has
> very high impedance and might be just the ticket. Pun intended.
>
> 73, Bill W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|