Barrie Smith wrote:
> Some time ago, there was a thread concerning HV connectors and HV wire.
> I did not pay too much attention at the time, because I had no needs,
> Things have changed, and I find myself building a small amp for 10 and 15M,
> only (My HB 10 through 160 has never worked on 10 or 15). The HV will only
> be 2 KV.
> I found the thread, but it appears to be one of those that went in all
> directions.
> I think the post that caught my attention was one by (I think) Bill, W6WRT.
> He mentioned a connector that was similar to a BNC where the ground had to be
> made before the HV was connected.
> I'd like to know what they are and where to get them.
The most important thing that I learned is to put the connector on the power
supply end of the
interconnecting cable so if it is not connected there can not be a wire with
high Voltage on it
rambling around.
--
Ron KA4INM - The next election, I know what is going to happen, I'm going
to help.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|