On 11/29/11 02:05 PM, Jim Thomson wrote:
> My hb 50 ohm dummy load consists of 4 x 200 ohm globars in parallel [type
> SP, glass bodied
> and suitable for oil immersion]. Each resistor is 1" diam x 12" long. [275
> W CCS in air]
> Each resistor resides inside it's own 2.875" OD x sched 40 Aluminum tube.
> All 4 x thick walled AL tubes are heliarc welded.
>
> I heard some place that instead of xfmr oil, that distilled water can be
> used instead?
> The same glass bodied type SP resistors, [50 ohm, high wattage] are used in
> water cooled loads,
> the type that has the garden hose on one end, etc.
IIRC the dielectric constant of water is about 80, so it is very high compared
to most other materials, so there is certainly the potential to increase
capacitances quite a bit, but depending on the sizes and spacing of conductors,
as well as frequency, that might not be an issue.
I'd certainly add corrosion inhibitor. The inhibitors for central heating
systems might be a good choice, as you don't need a lot of them, so I don't
think it would significantly reduce the specific heat capacity of the liquid.
Never tried it. I'd personally be a bit reluctant, but I can conceded there are
cost savings and spillage is less of an issue. My Bird load has a silicon oil,
but that stuff is expensive.
Dave
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|