My vote is for the grid resistor and cap
W5GHZ
________________________________
From: "TexasRF@aol.com" <TexasRF@aol.com>
To: w7why@frontier.com; amps@contesting.com
Sent: Friday, February 10, 2012 1:37 AM
Subject: Re: [Amps] SB-200
This wouldn't be a case of the input switch wafer out of alignment with the
output wafer would it?
73,
Gerald K5GW
In a message dated 2/8/2012 8:33:15 P.M. Central Standard Time,
w7why@frontier.com writes:
Hi All.
I have a SB-200 and it developed a problem in the last week or so.
When tuning up on 40, the Load cap is all the way meshed and the Tune cap
is
about 50% meshed. It puts out about 400 watts on 40. On 40, the input
SWR
is 1:1.
In 80 the Load cap is all the way meshed. It puts out about 200 watts.
The
input SWR is 1:1.
I checked to make sure the 2 sections of the Load cap were soldered
together
OK and they are. I disconnected the cap that is switched in on 80 and
replaced it with another one and still doing the same thing.
If the tubes are going soft, will it affect the tuning like that? Seems
like I've replaced the tubes before but never had the problem of the Load
cap being all the way meshed to load on 40. Thanks and 73
Tom W7WHY
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|