Amps
[Top] [All Lists]

Re: [Amps] Dentron 160-10L 10 meter issue

To: amps@contesting.com, Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
From: Tim Kass <k8wbl@yahoo.com>
Date: Fri, 7 Sep 2012 17:32:25 -0700 (PDT)
List-post: <amps@contesting.com">mailto:amps@contesting.com>
My doesnt have the zenier, its on a schematic but couldnt find it in my amp...

--- On Fri, 9/7/12, Carl <km1h@jeremy.mv.com> wrote:


From: Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
To: "Tim Kass" <k8wbl@yahoo.com>, amps@contesting.com
Date: Friday, September 7, 2012, 8:26 PM






Glad you clarified that. 
 
Ive seen late 160-10L's with the Clip L transformer (without the filament CT) 
and Ive seen late Clip L's with the Clip QRO transformer with the CT and SS 
zener control as well as the PC board that the tube sockets and input network 
were on.
 
With Dentron anything was possible and often done.
 
Carl
 
 
 

----- Original Message ----- 
From: Tim Kass 
To: amps@contesting.com ; Carl 
Sent: Friday, September 07, 2012 7:16 PM
Subject: Re: [Amps] Dentron 160-10L 10 meter issue





According the the Peter Dahl replacement transformer guide, not exact same but 
same voltage and same amperage



--- On Fri, 9/7/12, Carl <km1h@jeremy.mv.com> wrote:


From: Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
To: "Tim Kass" <k8wbl@yahoo.com>, amps@contesting.com
Date: Friday, September 7, 2012, 6:12 PM


I thought you said yours had the same transformer?

Carl


----- Original Message ----- From: Tim Kass
To: amps@contesting.com ; Carl
Sent: Friday, September 07, 2012 4:56 PM
Subject: Re: [Amps] Dentron 160-10L 10 meter issue


Well, the 160-10L doesnt have a high/low voltage position...has SSB/CW which 
only changes the speed of the fan...voltage remains the same..thats the 
design..in the Clipperton L - newer redesign of this amp, it has a hi-lo 
voltage switching in different taps on the primary I think.  That switch was 
bad so I replaced it with a on-off HD toggle, rather than the cheap-o 3 
position switch..so fan in high speed mode 100% of the time..but I changed that 
too with a 6 inch fan and put a resistor on it to slow it down a little as it 
was too damn loud.. hi hi   So far it hardly shows color..so hoping the tubes 
last forever.
Tim

--- On Fri, 9/7/12, Carl <km1h@jeremy.mv.com> wrote:


From: Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
To: "Tim Kass" <k8wbl@yahoo.com>, amps@contesting.com
Date: Friday, September 7, 2012, 2:32 PM


2100 is about right in standby on CW while 2600-2700 is fine on SSB.

I hope its just out of tolerance metering resistors and not the filter caps 
loading it down with high leakage.

Carl
KM1H


----- Original Message ----- From: Tim Kass
To: Carl ; amps@contesting.com ; Colin Lamb
Sent: Friday, September 07, 2012 11:53 AM
Subject: Re: [Amps] Dentron 160-10L 10 meter issue


Thanks Carl, well, only driving it with about 75 watts, wont go over that with 
my 746PRO to keep it happy...and not trying to sqeeze every last watt out 
either, like some folks.. ;)   When I rebuilt the power supply, could have 
redone that voltage doubler circuit, since it uses the same transformer at the 
Clipperton L, but didnt want to push the 572B's either, 2100 volts at idle now. 
So will just be careful and tune very slowly on the Tune knob, hate to write in 
tune positions but maybe stick some colorful tape on the exact loading 
spots..hi hi ...geez..its a junk style amplifier anyway and I've already cut up 
and modified it so much..don't think I can hurt the value of this amp any 
more..hi hi

73, Tim K8WBL


--- On Fri, 9/7/12, Colin Lamb <k7fm@teleport.com> wrote:


From: Colin Lamb <k7fm@teleport.com>
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
To: "Carl" <km1h@jeremy.mv.com>, "Tim Kass" <k8wbl@yahoo.com>, 
amps@contesting.com
Date: Friday, September 7, 2012, 11:31 AM


"Id start there and in the CW position and tune for maximum smoke."

Careful, Carl, there are a lot of hams out there who take every word as gospel 
and will try to do that.

73,  Colin




No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2437/5254 - Release Date: 09/07/12



No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2437/5254 - Release Date: 09/07/12 



No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2437/5254 - Release Date: 09/07/12
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>