Amps
[Top] [All Lists]

Re: [Amps] hf-2500

To: amps@contesting.com
Subject: Re: [Amps] hf-2500
From: Larry Benko <xxw0qe@comcast.net>
Date: Sat, 22 Dec 2012 09:25:27 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I used to think that shorted turns on powdered iron toroids was bad until I did some tests. My tests were not exhaustive but winding some #12 wire on a T200-2 core and shorting out some of the turns to reduce the inductance to ~1/2 of the inductance with the turns not shorted showed a moderate reduction in unloaded Q and a slight increase in temperature rise but nothing hugely significant.

I concluded that if shorting turns on an air core (u=1) was fine and shorting turns on a 60Hz transformer (u=10000 or more) was really bad then shorting turns on a powdered iron core (u=6 to 10) was much closer to the air core case than to the u=10000 case.

Of more importance is that toroidal cores are not easy to cool since they usually get connected to the chassis with an insulating washer beneath them and air flow not that good. Perhaps this leads to some of the reported failures.

73,
Larry, W0QE


On 12/19/2012 6:16 PM, Jim W7RY wrote:
Bill

We already had this discussion on here about a year ago. But I 'm going to repeat it.

Alpha, Ameritron, Jerry K8RA, myself W7RY, and many others all use toroids with shorted turns on our "L" coil in a PI-L circuit. It works just fine.

Do you mean that a shorted turn toroid for the PI network is not good? Or are you making a general statement that they don't work at all in an amplifier?


73
Jim W7RY


-----Original Message----- From: Bill Turner
Sent: Wednesday, December 19, 2012 12:26 PM
To: Amps
Subject: Re: [Amps] hf-2500

ORIGINAL MESSAGE:
On Wed, 19 Dec 2012 17:15:03 +0000, K1TTT wrote:

Agreed, that is why I have modified one to do only 40-10m... removing the
80m and 160m coils from the toroid removes the shorted turns problem and
makes it run very nicely doing rtty on 40m.

REPLY:
As David found out, shorted turns on a toroid or any iron core coil
are a no-no unless you do some very careful design and testing, which
Command obviously did not do. Shorted turns on an air core coil are
usually no problem. A word to the wise.

73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>