Any amp will be inefficient when used as a linear amplifier for AM because as
drive is reduced, efficiency is reduced. They will all generate a lot of heat
in this application. However, the AL-1200 should hold up well to the
lock-and-talk culture. In AM, PEP is 4X the carrier, Overall, you want the
carrier to be at 1/4 of the amp's rated PEP output.
Assuming the driver generates 100 W output, tune the amp for max or 1500 W
output (whichever comes first) with the amp in SSB mode. You want SSB mode
because you want the best linearity. Whether or not you use SSB or CW makes
little difference in the efficiency for your application but makes a big
difference in linearity.
Usually, when the driving rig is in AM mode, the carrier is reduced to 1/4 of
the max PEP SSB output. In such cases, you should see no more than 375 W
carrier power (375 x 4 = 1500).
If you are trying to drive it with an older plate-modulated tube rig, you ill
have to be careful if you reduce the power output because the modulation
transformer is designed with a particular output impedance in mind. If you
reduce the drive to the PA, the impedance changes and you will have to set the
proper audio level using a scope or modulation monitor.Start with audio gain at
zero, bringing it up slowly. Otherwise, you risk arcing in and destruction of
the modulation transformer.
Kim N5OP
On Thursday, October 30, 2014 8:05 AM, Gary Smith <Gary@ka1j.com> wrote:
One thing for sure, run it at the CW
setting, use the lower KV setting and you
will run far cooler for a given KW out.
73,
Gary
KA1J
> I want to run my AL-1200 on AM for a short stint (2 hours operating
> time, 50% overall duty cycle). I have tested it at about 225 watts
> carrier output, and with moderately high duty cycle transmissions (known
> in the AM crowd as 'Old Buzzarding'), it gets quite hot.
>
> What is the max recommended AM carrier power for long-winded transmissions?
>
> Also, I'm assuming it should be tuned up for proper operation at double
> the carrier power.
>
> I searched the list finding no real answers.
>
> Thanks,
>
> Tony, K1KP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|