Today I measured the filament voltage which is 13.5V. Spec is 11.9 to
13.3, so I think this OK.
At 08:50 PM 3/13/2018, Jim Thomson wrote:
I suspect the tubes available these days are all pulls or pulls of pulls
Jim - They have the appearance of unused NOS, still in the original packaging.
- Paul
Date: Thu, 08 Mar 2018 09:09:00 -0800
From: Paul Baldock <paul@paulbaldock.com>
To: amps@contesting.com
Subject: [Amps] GS35B Idle current increasing
<I built a GS35B amp a few years back to be used with my home brew AM
<rigs. Initially I set the idle current at around 110mA/4KV requiring
about -35V bias. Over a few years of very little use the idle current
drifted up so I increased the bias voltage to get it back down.
Eventually I was up to -55V with the idle current at around 180mA,
and so I installed another tube (purchased at the same time as the
first). Same deal as before, started at -35V, now at -55V.
Is this 2 bad tubes, or could I be doing something wrong? I'm getting
ready to install a third tube purchased from a different source.
- Paul KW7Y
## dunno about indirectly heated tubes.... but looking at eimacs tech notes
for directly heated tubes, its normal for idling current to
increase, as the tube
approaches the normal end of its life span. Your tube is not being
overdriven,
thats not the issue here. I suspect the tubes available these days
are all pulls,
or pulls of pulls. And if you try and increase
the filament voltage even more,
the idle current will also increase somewhat.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|