I built a GS35B amp a few years back to be used with my home brew AM
rigs. Initially I set the idle current at around 110mA/4KV requiring
about -35V bias. Over a few years of very little use the idle current
drifted up so I increased the bias voltage to get it back down.
Eventually I was up to -55V with the idle current at around 180mA,
and so I installed another tube (purchased at the same time as the
first). Same deal as before, started at -35V, now at -55V.
Is this 2 bad tubes, or could I be doing something wrong? I'm getting
ready to install a third tube purchased from a different source.
- Paul KW7Y
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|