Thanks! I was headed in that direction...
Now to make some room on the bench to work on it!!
Will
On 12/4/2018 11:02 PM, Bob Wilson, N6TV wrote:
From this document <http://www.ab4oj.com/dl/thp/hl2_5kfx/tuning.pdf>:
"If the POWER switch is turned on, while OPER/STBY switch is at
OPER(operate) position, the orange OPER lamp will
blink, and you will need to reset the OPER switch to enter into
operation mode. “PSE STBY OPERSW is displayed at this time."
Manual says something similar. So, if you are sure the OPER/STBY
switch is in the STBY position when you power up the amplifier, and
you're sure that nothing is plugged into the SEND jack by mistake
(like an ALC cable), and the amp. displays that message every time you
power up, then perhaps the OPER/STBY switch is defective or wired
backwards.
73,
Bob, N6TV
On Tue, Dec 4, 2018 at 5:19 AM William Liporace <wc2l@wc2l.com
<mailto:wc2l@wc2l.com>> wrote:
Hi Folks,
I'm having an issue with the THP HL-2.5Kf and I have a couple of
questions. I do have the 1.5C firmware. I have it hooked up to a
K3. The
amp is set to Yaesu band data. I know the amp used to work with a K3.
The amp never seems to leave "PSE STBY OPERSW!" on the display
after the
amp is powered up.
What causes the "PSE STBY OPERSW!" ?? Manual says power cycle the
amp to
reset it. I don't see any other answers... I have even pulled the
plug
and allowed it to sit...
It does not seem to matter if the radio is hooked up amp. Does not
matter if the the amp is in auto or manual mode. It also does not
matter
if it is in operate or standby. I wanted to check both fuses... One
fuse I can't seem to open and one of the fuses is fine, but the amp
powers up. My guess is that it is OK (bad thought?).
Any thoughts? Really could use some help with this!!
TNX Will WC2L
--
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node telnet dxc.wc2l.com <http://dxc.wc2l.com> or
144.93 MHz
wc2l@wc2l.com <mailto:wc2l@wc2l.com>
_______________________________________________
Amps mailing list
Amps@contesting.com <mailto:Amps@contesting.com>
http://lists.contesting.com/mailman/listinfo/amps
--
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node telnet dxc.wc2l.com or 144.93 MHz
wc2l@wc2l.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|