Ciprian,
Welcome to the list.
Absolutely the first thing you need to do is to NOT start CT in a window. Boot
directly to DOS and then proceed with running CT.
73 Mike N2MG
On Thu, 08 November 2001, Ciprian Sufitchi wrote:
>
> Hello everybody.
>
> I am new on this list and I am sure that this subject has been already
> discussed, but I need to teach me somebody how to do in the best way a
> small CT network via TNCs.
> I tested two computers conencted via TNC following instructions of
> www.k1ea.com site, but I am not satisfied.
> I don't know where from come problems, but I am trying to understand.
> Both computers were running Windows 98 OS and CTs were started in a DOS
> window. COMTSRs were OK, TNCs OK, connection OK, transparent mode. I've
> got a proper TNC connection between CTs and when a QSO was made by "1",
> appeared on "2"s log.
>
> The main question is:
> Let's suppose the connection is broken, not because of radio, but one
> computer crashes. The second node is not informed, of course. I reboot
> the broken computer, I start all application required etc. Now I want to
> connect to the alive computer to restore the link and the database,
> without needing to exit from CT and enter again, because this is time
> consumption.
> How to do this?
> Other questions:
> - networking is available only for multi-multi?
> - from setup screens, stations must select *different* numbers, or the
> same?
> - how many stations may be connected in a TNC network at the same time?
>
> Thanks for attention and see you in the contest!
>
> 73s de Ciprian YO3FWC
> _______________________________________________
> ct-user mailing list
> ct-user@contesting.com
> ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
________________________________________________
PeoplePC: It's for people. And it's just smart.
http://www.peoplepc.com
|