Regarding the signal, has anyone ever seen different signal results from
the RG-1100 than from the AP? I have several clients that show good
from the AP, but have packet loss when you connect to the RG and
initiate the link test. BTW, this is all TC. Thanks.
Steve Deaton
IT Director
Texas Broadband, Inc.
(888)868.3835 ext 85 (office)
979.289.0148 (office)
979.289.5117 (fax)
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Bernie Beckel
Sent: Thursday, June 26, 2003 8:58 PM
To: Norm Young; Karlnet Mailing List
Subject: Re: [Karlnet] First install of Ubicom-based CPE...
Norm,
I think we are talking about the same boards. I got some yestereday
from CW
labs.
Mine only has one RF connector but it is plugged into the PCMCIA card
via a
piece
of short coax.
I got our first one working today.
The network ID and the chan have to be the same on the AP you are
connecting
with.
I had to change a bunch of client radios and an AP to get this to work.
The signal meter doesn't work yet on the client but you can see the
correct
signal if
you look at it from the AP side.
The RF connector is a reverse SMA. The center conductor is female.
Like I said we may be talking about two different boards here.
Bernie Beckel
Crimson Wireless
----- Original Message -----
From: "Norm Young" <lists@applegatebroadband.net>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Thursday, June 26, 2003 7:32 PM
Subject: [Karlnet] First install of Ubicom-based CPE...
> I've got a couple of Ubicom boards enclosed in the AntennasAmerica
19dB
> panel/enclosure, and I'm trying to set one up for the first time.
Seems
> simple enough, with a web interface, can't mess it up, right? :)
>
> However, after installation in a place I know has good signal (-84dBm)
via
a
> Lucent Silver using the XP driver, I cannot get a signal. There are a
> couple of possiblities, I think: 1) Wrong RF connector, or 2) the
Ubicom
has
> much, much less RF sensitivity than the Lucent card. (Seems unlikely.)
>
> Since I've had to swap these boards out, (got 802.11b instead of TC
boards
> by mistake) there is some question on which of the two RF connectors
to
use
> on the board. I've currently got it in the connector closest to the
power
> connector. Swapping it over to the other seemed to make no
difference.
>
> I've set the Ubicom to the base station channel, (auto
selection/scanning
> doesn't work) but it reports nothing. The system passphrase is set
> correctly, but I don't see a place to enter the Network ID number like
you
> have to with the SR-4000.
>
> Anyone else had a setup experience with this hardware?
>
> Norm
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|