The initial run of KN-100 boards DID NOT have an active Temp chip- so it
is not automatic!
Kevin
**************************************
Kevin R. Knuth
Business Development Manager
North America
260-424-9690 Regional Office
614-822-5275 Corporate Office
kknuth@karlnet.com
www.karlnet.com
**************************************
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Norm Young
Sent: Tuesday, October 07, 2003 9:07 PM
To: Caleb Carroll; Karlnet Mailing List
Subject: Re: [Karlnet] kn100/200 temp readings
I'm assuming that I don't have that board, as I'm using J3 for a fan
header, and the temp reported is 31C and the fan keeps merrily blowing
away. Or...is there some software that has to be loaded to make it work?
It would be very, very nice to have this, as the fan does use a bit of
power, and it's at a real premium where I'm locating this radio. (solar)
During the winter, with the ambient so low, it would be nice not to have
the fan blowing frigid air over the radio, not to mention that sunlight
is a bit scarce during this time.
----- Original Message -----
From: "Caleb Carroll" <karlnet@pathcom.ca>
To: "Norm Young" <lists@applegatebroadband.net>; "Karlnet Mailing List"
<karlnet@WISPNotes.com>
Sent: Tuesday, October 07, 2003 9:45 AM
Subject: Re: [Karlnet] kn100/200 temp readings
FYI everyone: The new KN-100 & 200 boards now have temperature control.
The fan starts operating at 45deg C. When/if the board reaches 30deg C,
the fan will turn its self off. The fan comes on for a second or two
when you first apply power to the board and then shuts off.
*********** REPLY SEPARATOR ***********
On 2003-Oct-06 at 10:00 PM Norm Young wrote:
>Eric, you need the latest version of the KN-200 board AND/OR you need
>v4.43a, I'm gathering from the questions and input I'm getting to get a
>temp reading. It shows up on the Remote Statistics area in the
>configurator.
>
>Norm
>
>
>----- Original Message -----
>From: "admin " <admin@mail.warpspeedinternet.ws>
>To: <karlnet@WISPNotes.com>
>Sent: Monday, October 06, 2003 7:08 AM
>Subject: [Karlnet] kn100/200 temp readings
>
>
>> Hi all,
>>
>> Where do you get the configurator which shows the board temp? I
>> looked
>thru the Karlnet site and don't see it.
>>
>> TIA,
>> Eric
>>
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>>
>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|