I agree... if you absolutely have to use amps... (would try to avoid at all
cost) then YDI hasn't done me wrong in 4 years.
After using a spectrum analyzer near a Hyperlink amp, I would say that they are
pretty good at bleeding over into adjacent channels.
-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of Andy Thomas
Sent: Thursday, May 20, 2004 10:56 AM
To: Karlnet Mailing List
Subject: Re: [Karlnet] Amps
I'm running YDI amps at the antennas and injecting power at the base
stations. I did have to get Polyphasers on the antenna leads that pass DC
through. So far so good after about 2 years.
Andy Thomas
----- Original Message -----
From: "Scott Wendrick" <scooter@uplogon.com>
To: <karlnet@WISPNotes.com>
Sent: Thursday, May 20, 2004 9:08 AM
Subject: [Karlnet] Amps
> What brand are you all currently running for amps and how do they perform.
Also what location are you mounting the amps (after the radio or up by the
antenna). Thanks for the info
>
> Scott
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|