Orion
[Top] [All Lists]

Re: [Orion] Orion - how with ALC?

To: "OK1FM" <ok1fm@ges.cz>
Subject: Re: [Orion] Orion - how with ALC?
From: "Carl Moreschi" <n4py@arrl.net>
Date: Tue, 29 Nov 2005 15:59:24 -0500
List-post: <mailto:orion@contesting.com>
The ALC in the Orion is internal only.  There is no external ALC on any
tentec radio.  You simply adjust the "PWR" level on the Orion for the
correct drive level when in CW mode.  Then in SSB, the drive level will
never be more than this value.  You then adjust the mic gain level until the
red ALC light on the Orion flickers on voice peaks.   This will never
overdrive your amplifier as long as the steady state PWR level is correct
for CW mode.

Carl Moreschi N4PY
Franklinton, NC
----- Original Message ----- 
From: <Milan Gütter>; "OK1FM" <ok1fm@ges.cz>
To: <orion@contesting.com>
Sent: Tuesday, November 29, 2005 3:53 PM
Subject: [Orion] Orion - how with ALC?


> Orion owners,
>
> At my Orion 565AT I'am missing the ALC connector on rear panel.
> This is necessary for output power control
> based on ALC coming from external PA, such as Yaesu solid state Quadra PA.
>
> In the Orion manual (printed book, page 52) TEN-TEC writes,
> that Power Output is ALC adjustable 5-100W.
>
> My question is how connect the ALC from PA for do this?
>
> Any technical help will be appreciated.
>
>
> 73 Milan, OK1FM
> www.ok1fm.com
>
>
>
>
>
>
>
>
>
>
>
>
>


----------------------------------------------------------------------------
----


> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>

_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
<Prev in Thread] Current Thread [Next in Thread>